Black Witch contact cement is suitable for quick repairs to Neoprene, rubber, latex and vinyl. Repairs rips and tears and is also suitable for butt end jointing of seams or edges where the rubber is directly bonded together. Full instructions inside card.

Don’t let a rip or a tear stop you. Black Witch will patch that hole in your raft, fix the gash in your fishing waders and make sure you stay dry.

• Strong
• Flexible
• Abrasion resistant
• Waterproof
• Suitable for most materials

For quick, grab-and-hold repairs in the field, opt for Neoprene-based contact cement. Contact cements are formulated specifically for rapid tack and bonding. Black Witch™ Neoprene Contact Cement cures to full strength in only 30 to 60 minutes and creates a strong, durable, flexible bond.

Wetsuit repair is simple and quick with Aquasure NEO Black Witch (formerly Black Witch). Previously known as Seal Cement, this black contact cement is formulated to permanently bond with neoprene and other coated materials.

With this flexible liquid adhesive, repairing neoprene gear can be done within half an hour. Apply to waterproof waders, gloves, booties, and spray skirts by the water. Or re-seal a leaky gasket at home. When rips and tears happen, use this contact cement to repair stretchy, high-performance fabrics and protect it from abrasions. Before venturing out to that favorite fishing hole or dive spot, bring Aquasure NEO along for unexpected repairs and save that expensive gear.

• Fast Acting – Dries in 20 minutes for fast in-field repairs to wetsuits, waders and more
• Durable – Tough adhesive that bonds to neoprene, latex and rubber
• Flexible – Cures to an elastic rubber that stretches and bends with fabrics
• Abrasion resistant – Coat high-wear areas like knees and elbows to protect against abrasion
• Waterproof – Provides a water-tight seal to keep watersports gear performing no matter the activity

Instructions for use:

Use BLACK WITCH to seal leaky gasket seams. 

STEP 1: Apply Black Witch on both edges of the repair area. Allow to dry for 5 minutes or until touch dry.

STEP 2: Press and hold edges together until adhesive cures.

STEP 3: Ensure surfaces are fully bonded before use.